Your water heater is one pretty used and much more costly appliances in your home, and consumes a large associated with your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving on your home heating as well as costs.
Regular flushing of the water heater has become single most important step you get to prolong its service life this particular save energy. In a period of time, sediments enhance in the bottom of your hot water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. In part destructive to the tank, but highly inefficient and will significantly raise your heating costs.
In most regarding the country, the typical water heater lasts 3-5 years. Regularly flushing your water heater can double living of your water heater from 3-5 to 7-10 years. Device costs of replacement running from $700 to over $1200 in some cases, getting the most from your heater is critical in today’s economic condition. In addition, regular flushing makes your water heater run more efficiently and can cut heating costs in half. Depending on the volume of drinking water your home uses, that can mean a savings of $20 to over $50 a month or so.
To drain your water heater, initially you should set the thermostat to pilot (if it can be a gas water heater) or turn the circuit breaker off (if it can be an electric heater). Failure to do so could result in overheating and severe damage to the actual heater. Next, close the water supply valve located on the water inlet line going into your water heater. After backing up connect a garden hose to the drain valve located at the bottom of the heater. Open the drain and allow it to move until all from the water has emptied from the unit. Then close the drain. Open the water supply valve and refill the heater. You should also open a hot water faucet somewhere inside the house and stand there and watch it run for several minutes until drinking water flows out perfectly. This will allow air to vent because of the heater and the water lines. Finally, you can turn the thermostat to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).
Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system home to filter or condition the water so is certainly less corrosive to your plumbing system, particularly in areas which have hard this type of water. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in your area to discuss options and merchandise to fit the bill.
Abacus Plumbing, Air Conditioning & Electrical
The Woodlands, TX
(281) 528-1610